Motec ADR2 Features:

Configurable thresholds to trigger an event – password-protected feature
Configurable thresholds to trigger the medical light output – password-protected feature
Support for external medical and status lights
CAN and GPS inputs for data recording
Internal backup power to continue recording if power is lost
Real-time clock for accurate time keeping
Password protection restricts selected features to FIA access only

motec ADR2

Communication Specifications:

CAN for transmitting and receiving FIA-specified data
RS232 for receiving GPS data
USB for communication with ADR2 Manager

Connector:

1 x 13 pin Autosport connector size 10

Physical construction and dimensions

Case size: 86 mm x 45 mm x 25 mm
Case material: anodized aluminum
Ingress protection rating: IP66 / IP67
Operating temperature: -40 to 85 °C
Weight: 130 g

Power:

Power supply: 6 – 32 V
Current: nominal 200 mA @ 12 V (with external GPS), maximum 1 A when charging backup power supply
USB power when connected to PC (when no other power source is connected)
Backup power supply
Provides power for at least 45 seconds of continuous recording after vehicle power is lost
Recharges in less than one minute after vehicle power is applied

Medical and status light outputs:

Topology: current limited open collector high-side drive
External load: LED to GND or logic level input with a pull-down resistor
Voltage on: 5 V – Regulated
Voltage off: 0.3 V (with external 10k load to ground)
Voltage off: 2 V (approximately, when not connected)
Current Limit: 20 mA
Reverse polarity protected
Voltage diagnostic feedback

Operational:

Recording of lateral, longitudinal, and vertical accelerations at 3000 Hz
Recording of CFC60 filtered acceleration data at 1000 Hz
Acceleration channel resolution: 0.125G
Recording of FIA-specified CAN channels
GPS data recorded:
Date and Time
Latitude and Longitude
Accelerometers range: -480G to +480G
Accelerometers overload: 1800G minimum
Pre-event recording: 15 seconds
Total event recording: minimum 30 seconds, extended on the subsequent impact
Data output format: CSV

Brand

Motec

Over the past 20+ years Motec has set the standard for Motorsports Engine management systems, Data Loggers, Dash Displays and of course the data analysis software used to support, tune and analyze engine, chassis and driver related data. Our team of tuners has over 25 years combined experience with Motec and are here to support each customers individual goals. Whether you have a high power street car, rally, circuit, drag, drift, touring car or water craft we are happy to support your goals and make dreams come true on the track, street or water. For custom applications please email tuning@brewedmotorsports.com or call 888-290-3213. If we do not answer the phone be sure to leave a voice mail with your contact info and one of our Motec tuners will contact you within 24 business hours. Customers looking for Motec support at the race track for individual events or full season service should contact us as early as possible. We book up fast during the race season so if your team needs support this season or next send us an email today. Both on site and remote track support services available for Motec support and data analysis for single or multi car teams.