Clutch Masters 725 Series Street Twin Disk Clutch Kit for 2018-2021 WRX Without Flywheel
Even with basic bolt on mods the FA20 motor in your WRX will produce close to 300HP. At this power level the stock clutch becomes incapable of supporting the upgrades and more aggressive driving from track days. The 725 twin disk clutch offers a significant increase in holding capacity over factory clutch and is a must have to put the power to the ground for any track ready WRX while also shaving rotating mass from your engine!
This 725 series street kit is a 7.25″ (184mm) twin disc clutch (one ceramic and one organic disk) with a custom cover plate that is machined from billet aluminum and is then Type 3 hard anodized. By machining the strongest cover possible while maintaining minimal weight, Clutch Masters was basically able to eliminate any flex in the cover. The billet covers see only .003″ of flex where as a cast or stamped unit can see as much as .030″ of flex. By eliminating this flex in the cover, the driver is able to operate the clutch much more consistently and confidently. The strength of the covers also results in greater clamping force over the same amount of area vs a cast or stamped cover. This means the twin discs are easy to drive and have superior clamping force to make sure all the power your engine is making is being utilized.
While being very similar to the Race version of this twin disk clutch kit, the difference is the second disk is organic rather than two ceramic disks. This is done to make for an easier engagement in stop and go situations for the driver, while still providing the un-surmounted horsepower/torque holding capacity of a twin disk setup.
What makes the 725 kits truly special, and a feature unique to Clutch Masters is the QR System, or Quick Release Pressure Plate. The QR System Incorporates three spring-loaded bolts allowing the pressure plate to engage and disengage evenly and smoothly while reducing internal clutch noise/chatter by up to 50%. The QR System was developed to provide quiet and smooth operation for the user while delivering the performance a race clutch needs.
- Hard Anodized Aluminum Cover Assembly with attached Diaphragm
- Titanium reinforcement bushings for the Quick Release Pressure Plate system.
- Pressure Plate Ring
- Quick Release Pressure Plate System
- One Ceramic Rigid Disc
- One Organic Rigid Disc
- One Floating Mid Plate
- Release Bearing
- Pilot Bearing
- Pressure Plate Bolts
Flywheels are made for each specific application in steel and meet SFI spec 1.2 for competition in NHRA, NDRA, IDRC, IHRA, SCCA and NASA.
This kit is specifically designed for the serious drag racing with very significant modifications to their WRX, and most importantly one of our infamous Brewed tunes.
**Flywheel not included but required. 15020-TD7S-A is the same kit with the aluminum flywheel included**
What others are saying
There are no contributions yet.